This page is the continuation of analysis and design of 2D Truss using Staad Pro software.The remaining steps are as shown below
39. Nodal load 🡪 Fx 15kN 🡪 click Add.
40.Fy -30kN 🡪 click Add.
41.Fy -45kN 🡪 click Add.
42.Fy -60kN 🡪 click Add.
43.Mz 40kNm 🡪 click Add.
44.Assign Selfweight to View.
45. This is the output.
46. Select the node and use cursor to Assign Fx 15kN.
47.Select the nodes and use cursor to Assign Fy -30kN.
48.Select the nodes and use cursor to Assign Fy -45kN.
49.Select the node and use cursor to Assign Fy -60kN.
50.Select the node and use cursor to Assign Mz 40kNm.
51. Click on Analysis 🡪 Perform analysis .
52.Click on No print 🡪 click oK.
53.Click on Post analysis print 🡪 Analysis Results.
54.Click ok on the tab.
55.Analyze 🡪 Run analysis .
56. Click on stay on the modeling mode and click Done.
57. Click on Design 🡪 Steel design.
58. Select IS 800 from Drop down menu.
59. Click on member take off 🡪 ADD .
60.Click on take off 🡪 ADD .
61.Assign member take off 🡪 To view .
62.This is the output.
63.Assign take off 🡪 To view .
64.This is the output.
65.Analyze 🡪 Run analysis
66. Click on save.
67.View output file 🡪 Done .
68.View of results 🡪 Member forces.
69.View of results 🡪 Steel take off .
70.Click on Mode 🡪 Post processing.
71.Click on DL 🡪 Click Ok.
72.Click on Node 🡪 Reactions.
No comments:
Post a Comment